5
!
!
!
WARNING:
Keep the extension cord
clear of the working area.
Position the cord
so it will not get caught on the work piece,
tools or any other obstructions while you are
working with the power tool.
Make sure any extension cord used with this
tool is in good condition. When using an
extension cord, be sure to use one of heavy
enough gauge to carry the current the tool will
draw. An undersized cord will cause a drop in
line voltage resulting in loss of power and
overheating.
The table at right shows the correct size to
use according to cord length and nameplate
ampere rating. If in doubt, use the next
heavier gauge. The smaller the gauge
number the heavier the cord.
Be sure your extension cord is properly wired
and in good condition. Always replace a
damaged extension cord or have it repaired
by a qualified electrician before using it.
Protect your extension cord from sharp
objects, excessive heat and damp or wet
areas.
Use a separate electrical circuit for your
power tools. This circuit must not be less
than 14 gauge wire and should be protected
with either a 15 AMP time delayed fuse or
circuit breaker. Before connecting the power
tool to the power source, make sure the
switch is in the OFF position and the power
source is the same as indicated on the
nameplate. Running at lower voltage will
damage the motor.
WARNING:
Repair or replace
damaged or worn extension cords
immediately.
Select the appropriate extension cord
gauge
and length using the chart below.
When operating a power tool outdoors,
use an outdoor extension cord marked
“W-A” or “W”.
These cords are rated for
outdoor use and reduce the risk of electric
shock.
WARNING:
Keep the extension cord
clear of the working area. Position the
cord so it will not get caught on the work
piece, tools or any other obstructions
while you are working with the power tool.
EXTENSION CORD SAFETY
