1
0
2
!
This oscillating tool has been designed for use
with either open back or closed back
accessories. No tools are required to install
open back accessories. A 5mm hex key is
required for installing closed back accessories.
3
4
5
1.
Use the 5mm hex key (1) to remove the
closed back accessory screw (2) and the
two closed back accessory blade holder
components (3) (Fig. 1).
NOTE:
Save these blade holder components as
they are required for installing closed back
blades on the tool.
Fig. 1
Installing closed back accessories
The closed back blade mounting system
the use of closed back accessories with this
oscillating tool. For convenience, either closed
back or open back accessories may be used.
For illustrative purposes, an open back blade
shown.
1.
Lift the tool less accessory holder release
lever (4) up and toward the front
as far as it will go (5) (Fig.
INSTALLING ACCESSORIES
All accessories are installed on this oscillating
tool in a similar manner. For the purposes of
describing the accessory installation, the
triangular sanding pad and the metal cutting
blade have been illustrated.
DANGER:
Always remove the plug from
the power source before installing or removing
accessories or sandpaper. Failing
to remove the plug from the power source
may result in the tool accidentally
being
started and causing serious injury to the
operator.
Installing open back accessories
NOTE:
This will open the tool
(6) to accept the accessory.
2.
Insert the accessory mount (7) into the
opened accessory holder.
3.
Align the accessory mounting slots and
holes with the accessory mounting
(8) in the accessory mount.
NOTE:
The slots and holes in the accessory
must be engaged with the matching teeth on the
accessory holder to allow the accessory to be
secured within the accessory holder.
4.
Move the tool less accessory release lever
back to it’s original position (4) to clamp
accessory into the accessory
NOTE:
Check to make sure the accessory
mounting pins are still aligned with the slots and
holes in the accessory mount.
5
7
Fig.
ASSEMBLY AND OPERATING
NOTE:
The drawings in the assembly and
operating section of this manual may differ
slightly from the tool you purchased.
This oscillating tool has been only designed for
use with open back accessories.
accessories
The closed back blade mounting system allows
closed back accessories with this
oscillating tool. For convenience, either closed
open back accessories may be used.
For illustrative purposes, an open back blade is
Lift the tool less accessory holder release
lever (4) up and toward the front of the tool
it will go (5) (Fig. 2).
This will open the tool less blade holder
(6) to accept the accessory.
Insert the accessory mount (7) into the
holder.
Align the accessory mounting slots and
holes with the accessory mounting teeth
(8) in the accessory mount.
holes in the accessory
must be engaged with the matching teeth on the
accessory holder to allow the accessory to be
secured within the accessory holder.
Move the tool less accessory release lever
back to it’s original position (4) to clamp the
accessory into the accessory holder.
Check to make sure the accessory
mounting pins are still aligned with the slots and
holes in the accessory mount.
4
6
8
Fig. 2
OPERATING
