Fast H-NAPE CHINSTRAP, Operator'S Manual, Page: 8 / 24

H-NAPE CHINSTRAP OPERATION
LOOSEN HEAD-LOC SLIDERS
•
With the helmet off, loosen all (4) Head-Loc Sliders by sliding
them away from the chincup.
CONNECT CHINSTRAP BUCKLE
•
Place the helmet on your head and connect the low profile
chinstrap buckle. This is easiest when placing your index fingers
behind each side of the buckle as shown.
TIGHTEN FRONT STRAPS
•
T ighten the front straps by pulling the Head-Loc Sliders toward your chin.
This is easiest when holding either side of the slider with your thumb and
middle finger while using your index finger in the top recess.
ADJUST NAPE PAD
•
Position comfortably (as low as possible) on the back of your
head. Pull Head-Loc Slider with your right hand.
TIGHTEN BACK STRAPS
•
W
ith both hands, pull the two Rear Head-Loc
® Sliders on the
lower webbing straps toward your chin until snug.
Note: The technique works best if you only hold the
plastic sliders and don’t touch the webbing.
Head-Loc
Slider