Fast H-NAPE CHINSTRAP, Operator'S Manual, Page: 7 / 24

WORM-DIAL FIBAND OPERATION
LOOSEN HEAD-LOC SLIDERS
•
With the helmet off, loosen all (4) Head-Loc Sliders by sliding
them away from the chincup.
CONNECT CHINSTRAP BUCKLE
•
Place the helmet on your head and connect the low profile
chinstrap buckle. This is easiest when placing your index fingers
behind each side of the buckle as shown.
TIGHTEN FRONT STRAPS
•
W ith both hands, pull the two Front Head-Loc Sliders on the
webbing straps that come from the front temples of the helmet
toward your chin until snug.
ADJUST WORM DIAL
•
T
urn the Worm-Dial Adjustment to tighten the fitband until it
is comfortably snug.
TIGHTEN BACK STRAPS
•
W
ith both hands, pull the two Rear Head-Loc
® Sliders on the
lower webbing straps toward your chin until snug.
Note: The technique works best if you only hold the
plastic sliders and don’t touch the webbing.
Head-Loc
Slider
7