Fast H-NAPE CHINSTRAP, Operator'S Manual, Page: 19 / 24

ADDITIONAL PADS
(Also Included)
(1) Thin x2 Pad
(1) Thin x4 Pad
S/M M/L & L/XL
H-NAPE PADS
WORM-DIAL PADS
ADDITIONAL PADS
(Also Included)
(1) Thin x2 Pad
(1) Thin x4 Pad
S/M M/L & L/XL
REPLACEMENT CHINSTRAP & LUX LINER
REMOVE OLD WORM-DIAL FITBAND FROM LUX LINER
Place your index finger behind the front center of the Worm-Dial Fitband and carefully bend away
from the Impact Liner as shown. Pinch the Fitband and use your thumb to slide the pad sideways ½”
towards the center of the helmet along the Impact Liner. Repeat on both sides until the pad is released
from the key slots. Detach back of Fitband by simply peeling it away from the Velcro Circles it is
attached to.
Note: Do not pull the Front Fitband away from the Impact Liner or you may break the
Key Slots.
REMOVE LUX LINER PADS
Remove all Lux Liner Pads from the Lux Liner’s Impact Liner. Pads are attached to the Lux Liner by
Velcro Circles. Front row 4x or 5x pad for Worm-Dial version is held onto the Fitband by Velcro Circles
and Tabs. It can be easily removed by peeling away from the Impact Liner.
H -Nape Chinstrap version can be easily replaced by unscrewing hardware, removing old H-Nape
Chinstrap and installing new Chinstrap.
19
Insert the new Worm-Dial Fitband into the Key-Slots of the front Impact Liner by bending the Fitband
in the center and pushing on the rivets (one at a time) with your thumb while at the same time sliding
them toward the sides of the helmet. Then attach Lux Liner Pads.
Impact Liner
Front of Fitband
All Pads Removed All Pads Attached
LUX LINER REPLACEMENT PAD KIT INCLUDES THE FOLLOWING PADS: