“PRE-LOAD” THE FITBAND
•
You can set the shape of the fitband to
match the shape of your head for long
term comfort.
•
P
ush or pull the rear fitband liner tabs
(used for height adjustment in step 3)
to adjust the fitband tension from a
round to more oval shape.
•
Hold each rear fitband liner tab with
your hand in the location that sets the
fitband tension in the optimal shape
and then tighten the back screws to lock
the tabs in place.
INSTALL THE SIDE PADS
•
Install the side pads onto the Velcro patches
on the inside of the helmet. These pads
make the helmet more stable and increase
protection from side impacts.
•
If they feel tight or uncomfortable, try to
relocate them into a position that feels good.
Note: Check that all screws
and accessory hardware are
tight and secure.
YOUR HELMET IS
READY FOR USE!
TIGHTEN BACK SCREWS
•
Tighten the back screws to lock the
rear fitband liner tabs, chinstrap and
side rails permanently in place.
•
If you don’t do this, all of the
adjustments you just made will slip
and the helmet will likely come apart.
7
