ZL1 WSC14
7
2. Lift the machine (see photo 1)
3. Remove the hose from the squeegee assembly (see
photo 2).
4. Loosen the 2 screws as shown in the picture to
remove the squeegee (see photo 3).
5. Carefully clean the squeegee and squeegee holders.
6. Reassemble everything.
Note:
Each squeegee has four working edges. If you flip
over the squeegee and put it back into the assembly, you
can reuse it until all the edges are worn down. (Working
edge of squeegee should be square and meet the ground
properly).
Showing all parts of squeegee assembly:
Removing the Scrub Brush
1. Raise the squeegee assembly. (See photo 5).
2. Lift the machine by pushing down on the handlebar.
3. When the base is lifted, turn the brush control
clockwise. The brush releases automatically.
Weekly Maintenance Instructions
Clean the Vac Hose
Weekly or whenever the vacuum
loses suction, it is necessary to
flush out the vac hose as follows:
1. 1. Remove the hose from the
squeegee assembly.
2. 2. Unplug the other end from the
recovery tank.
3. 3. Wash the inside of the pipe with
a jet of water, from the side that
plugs into the tank as shown.
4. Reassemble the hose.
ATTENTION! DO NOT WASH THE PIPE THAT
CONNECTS THE VACUUM MOTOR AND RECOVERY
TANK! DOING SO MAY DAMAGE VAC MOTOR!
Clean the Solution Tank
1. Unscrew the plug on the solution tank.
2. Flush the inside of the solution tank with clean water.
3. Remove tank and dump.