ZL1 WSC14
3
operate carefully around other workers in the area. Keep
children away from the machine.
Use only manufacturer-recommended low foam cleaning
detergents in the machine. Follow chemical manufacturer
directions for mixing and dilution ratios.
Warning:
Do not use in an area where explosive or
corrosive vapors, such as gasoline fumes or paint thinner,
are present.
Warning:
Do not use acetone or other harsh solvents in or
around the scrubber, as this may cause corrosion to
sensitive machine parts.
Warning:
Do not operate scrubber on floor surface where
the slope exceeds 5%.
Maintenance and repairs should be done only by factory-
trained personnel. Contact manufacturer or local dealer for
more information.
When cleaning, servicing, transporting, or performing
maintenance on the machine, be sure to turn off
machine, and disconnect the power.
Warning:
Do not use steam or pressure washer to clean
the scrubber as this may allow water into electrical
components, and damage the machine.
Be sure that brush, squeegee, hoses, solution and
recovery tanks are properly fitted before using.
Do not attempt to operate or perform maintenance on the
machine in a manner other than recommended by manu-
facturer.
User Responsibility
ZL1 WSC14 is designed for scrubbing and vacuuming
indoor hard floor surfaces. (It is not intended for parking
lots, sidewalks, or other outdoor areas). Please follow the
manufacturer’s instructions for operation, maintenance,
and transportation of machine as given in this manual. If
the machine is operated outside manufacturer’s guidelines
and recommendations, the manufacturer will not be held
liable for the consequences.
Machine should be operated, maintained, and repaired by
trained personnel. Operators must comply with accident
prevention, safety, and health regulations.
Do not make changes or modifications to the machine
without manufacturer’s consent. Manufacturer will not be held
responsible for damages resulting from such changes.
Unpacking the Machine
Please carefully inspect whether there is damage to the
packing crate of the machine. If there is, please imme-
diately notify your carrier.
The machine should arrive in a cardboard box of the
approximate dimensions as shown in the following
diagram. If you are transporting or shipping multiple
machines, we recommend stacking no higher than four
packages.
A
: 20”
B
: 18 ¼”
C
: 37 ½”
1. Open the top of the cardboard box.
2. Carefully remove the machine from the packaging, and
cut straps, cords, and fastenings.
3. Remove machine from pallet.
4. Take out the recovery tank, charger, and scrub pads.
Battery Instructions
ZL1 WSC14 comes standard with two 12 volt lead acid
(wet) rechargeable batteries, and 24V/15A battery charger.
Optional no-maintenance gel
batteries are available. Consult
your local dealer for details.
Battery dimensions should not
exceed (L/W/H):
10 ¾”, x 3 ½”, x 7
¾”. The battery weight should not
exceed 26.5 lb. per battery.