b.
“NO LOAD” (fig. 13)
In this case the load exceeds the max lifting value of the selected manual
extension (it could still be on the ground). Unhook the load since it cannot
be lifted using the selected manual extension. As in the preceding case, if
you keep pressed the "F2" key, it is possible to have an indicative evalua-
tion of the weight applied on the hook (fig. 11).
c.
“NO SPEED” (fig. 14)
The load has been lifted too quickly; the whole procedure must be repeated
from the beginning. The "LMI" key on the push-button panel or "F2" key on the
control panel is disabled because it has not been possible to calculate the
applied weight. Press INDEX on the push-button panel or "F1" key on the con-
trol panel to exit the procedure and go back to the standard operation. Put
down the load on the ground and repeat the whole procedure from the begin-
ning.
d.
“NO LOAD CRANE!” (Fig. 15)
This message informs that the lifted load exceeds the max limit value of the
crane/jib, irrespective of the manual extensions, so that the load cannot be lifted
in this configuration due to the crane/jib overload. Also in this case the load must
be either removed or approached to the crane, and handled in a different way
without using the selected manual extension. Moreover the whole procedure
must be repeated from the beginning.
18.2
USE OF IMPLEMENTS
GR2_45»60_3_4_5
fig. 13
fig. 13
fig. 13
fig. 13
fig. 13
fig. 13
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com