www.fassride.com
(866) 769.3747
STEP 1:
INSTALL ELECTRICAL HARNESS
D
.
Route the single red wire of WH-1006-3 to the engine bay fuse panel. Remove a fuse (maximum
of 10A) that is “hot” when the key is on. Use a test probe to locate the “hot side” of the circuit in the
fuse block. Install the Add-A-Circuit into the open location. Install the pulled fuse into the open space
on the fuse tap.
E
.
Route WH-1006-3 wire harness along frame rail to mounting location of pump. Completion of
this step will be addressed in the mounting step.
NOTE: FUSE LOCATION MAY VARY FROM
PICTURE!!
