Fasep 2000 srl
Rev. 1.8
Balatron 222/212: User’s Manual
23 January 2020
i
General Safety Requirement
[
before using/servicing this unit
]
1.
Read this instruction manual before operating or servicing the wheel balancer.
2.
Make sure electrical power source conforms to requirements shown on nameplate (see also model identification chart
for reference).
3.
Make sure the unit has a stable position and it’s bolted to the ground.
[when using the unit]
4.
Protect power leading to the unit from damage.
5.
When work area is being washed, make sure unit is adequately protected.
6.
Remove all stones and mud lodged in tire treads before balancing the wheel.
7.
Do not touch spinning wheel.
8.
Make sure counterweights are securely attached before checking residual unbalance.
[when servicing the unit]
9.
Make sure power sources are disconnected before service on the unit is performed.
10.
Service to PCB, electrical and mechanical parts should be done only by an Authorized FASEP 2000 Service Center.
C:
Errors and Malfunctions recognized by the Computer
Errors may apply to some model only.
ERR 1:
Shaft does not rotate
ERR 2:
Rotation Direction is wrong
ERR 3:
Rotation speed is not ready
ERR 4:
Rotation speed is wrong (too low or too high)
ERR 5:
Position Sensor or Position Disk failure
ERR 6:
Safety Safety cover is open
ERR 7
:
Measuring cycle was interrupted
ERR 8:
Calibration weight was not inserted.
ERR 9:
Activation code not correct
ERR 10:
Overflow in calculations
ERR 11:
Serial number is wrong
ERR 12:
Serial number not inserted
ERR 13:
Reserved
ERR 14:
Uncorrected password
ERR 15:
E²prom error
ERR 16:
Calibration memory error
ERR 17:
Rod in uncorrected position
ERR 18:
Excessive weight detected
ERR 19:
Reserved
ERR 20:
Excessive Deceleration
ERR 21:
Error in inputting data
ERR 22:
Brake error
ERR 23:
Reserved
ERR 24:
Insufficient air pressure (PL version)
ERR 25:
Reserved
ERR 26:
Piezo sensor error
ERR 27:
Wheel
is not securely tightened on the shaft
ERR 28:
Laser error
ERR 29:
Reserved
Summary of Contents for B222
Page 1: ...www fasep it User s MANUAL B222 B212 B112...
Page 20: ......
