FASCINATION 700 SYSTEM QUICK SETUP
Spray Unit Setup
Please read through all setup directions and recommended settings before you
attempt to operate your spray tanning system.
Spray Applicator Setup
Operation & Fan Pattern Settings
Congratulations on choosing the Fascination 700 HVLP Tanning Pro System!
Your system includes the following items:
• 1 Fascination 700 HVLP Tanning Pro Turbine Spray Unit
• 1 Fascination 700 HVLP Tanning Pro Spray Applicator with Cup
• 1 Fascination 700 HVLP System Hose
• 1 Spare Applicator Cup with screw storage cap
• 1 Manual
1. Attach hose to spray unit. The round end with two “pegs” inserts into the machine and
needs to be turned counterclockwise until it locks into place.
2. Attach power cord into machine and plug into wall outlet.
3. Turn on by pressing the power button located on the front control panel of the spray
unit.
1. Attach hose to applicator. The end with the “L” shaped notch will insert into the applicator
hose inlet (#10). The hose will align even with the applicator handle if screwed in properly.
2. Unscrew the solution cup and fill it 1/2 full with water to test the hookup and assign the
settings. Do not fill over 3/4 full as this may cause leaking especially during daily setups.
3. Insert cup (#7) into cup assembly (#9) and screw in tightly. Be careful never to
over-tighten the cap since it can strip the threads or crack the cup assembly.
1. Turn the setting to HIGH on the spray unit and adjust spray according to desired solution
delivery rate. Most tanning solutions require a HIGH setting on the spray unit but thinner
solutions may need a MEDIUM setting - it is best to start at HIGH and adjust downward.
Your goal is a 4 inch wide spray pattern spraying 4-6 inches away.
The LOW setting is for
the built-in heat dry feature (see step 5).
The spray tanning unit and applicator are now ready for start-up.
1
