
6-8
life of your vehicle than the period between
zero and 25hours.
For this reason, we ask that you carefully
read the following material. Because the
engine is brand new, you must not put an
excessive load on it for the first several
hours of running.
During the first 25 hours, the various parts in
the engine wear and polish themselves to
the correct operating clearances.
During this period, prolonged full throttle
operation or any condition which might result
in excessive engine heating must be avoided.
However,
momentary
(2-3
seconds
maximum) full throttle operation under load
does not harm the engine.
Each full throttle acceleration sequence
should be followed with a substantial rest
period for the engine by cruising at lower
r/min so the engine can rid itself of the
temporary build up of heat. If any
abnormality is noticed during this period,
consult a dealer.
0-10 Hours:
Avoid continuous operation above half
throttle. Allow a cooling off period of five to
ten minutes after every hour of operation.
Vary the speed of the vehicle from time to
time. Do not operate it at one set throttle
position.
10-25 Hours:
Avoid prolonged operation above 3/4 throttle.
Rev the vehicle freely but do not use full
throttle at any time.
After Break-In:
The vehicle can now be operated normally.
Brake System Break-in
Apply only moderate braking force for the
first 50 stops. Aggressive or overly forceful
Summary of Contents for 400UTV
