6.0 Battery Replacement
Transmitters include a replaceable CR2032, 3.3V, lithium battery
1
. The battery should be replaced when a button press does not result in a flash
of the LED, reliable read range, and/or an output from the Receiver. To replace the battery, follow the directions below:
1. Using a coin, place it in the gap (2-piece unit) near the key ring holder and twist to pop the transmitter open.
2. Remove the old battery
2
.
3. Insert the new CR2032, 3.3V, lithium battery. Be sure the plus (+) side of the battery is facing up (visible when installed).
4. Snap both pieces together.
7.0 Range
3
Read range between the Transmitter and Receiver depends on the Receiver model being used. Please review the Ranger Receiver datasheet for
more information.
8.0 troubleshooting
issue/Possible Cause
Corrective action
No data received/Transmitter not enrolled
Transmitter must be clicked twice to be learned by the Receiver upon initial Receiver power up
Short Read Range/Receiver Knob
Adjustable knob should be set to the maximum setting (certain models only)
Some Buttons not working/Receiver Capability
Receiver model WRR-42 requires adjusting button selection jumper. Receiver Model WRR-22
only works with the WRT-2+ (2-button Transmitter)
Prox insert not working/Compatibility
Support with HID and AWID 125-kHz Proximity Protocol readers must be requested on PO
Should any of the corrective actions mentioned above not improve performance, please contact Farpointe directly.
1. This lithium battery is widely available, and commonly used in electronic devices, including cameras and remote controls.
2. Dispose of the battery according to local requirements. Recycle when possible.
3. For best performance the Transmitter should be used as far from interference sources as possible. These sources may include, but are not limited to, large metal
obstructions, such as duct work and appliances, as well as magnetic fields and radio emissions.
Many Farpointe Data Readers carry the following certifications:
FCC compliance Statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Product can be used without license conditions or restrictions in all European Union countries, including Austria, Belgium, Bulgaria, Cyprus,
Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Poland, Portugal, Romania, Slovakia, Spain, Sweden, United Kingdom, as well as other non-EU countries, including Iceland,
Norway, and Switzerland.
Farpointe Data reserves the right to change specifications without notice.
P
/N
: 0
16
0
2
-0
01 ∙ R
ev
. 0
1.
15
© 2012-2015 Farpointe Data, Inc., a DORMA Group Company. All rights reserved.
Farpointe Data
®
, Pyramid Series Proximity
®
, Delta
®
, and Ranger
®
are the registered
U.S. trademarks of Farpointe Data, Inc. MIFARE is a registered trademark of NXP
B.V. AWID is a trademark of Applied Wireless Identifications Group. HID and the
HID logo are registered trademarks of HID Global Corporation, an ASSA ABLOY
company. All other trademarks are the property of their respective owners.
quick start guide
433-MHz RangeR
®
Long-Range
wiReLess Radio tRansMitteR
Farpointe data, inc.
1376 Borregas Avenue
Sunnyvale, CA 94089-1004 USA
Office: +1-408-731-8700
Fax: +1-408-731-8705
[email protected]
www.farpointedata.com
