INSTALLATION
5
CONNECTIONS
Because of the high performance of the
DVP5000 it is very important to use the highest
quality cables possible, for both input and out-
put signals.
Both the RGB BNC and the D15 Monitor output
connections are active at all times and can run
two displays simultaneously.
To avoid AC ground loop problems, the source
equipment, DVP5000 and projector should all
be running on the same AC power line (one
correctly rated for the power requirements).
SOURCE INPUTS
1
1. S-Video (Y/C) sources such as DVDs,
Satellite systems, S-VHS tape decks
(when using S-VHS tapes only), Hi-8 tape
decks.
1
2. Composite video sources such as
Laserdisc players, cable TV, VHS tape
decks, 8mm tape decks.
1
3. Interlaced Component video sources such
as DVDs and professional tape decks.
Progressive Component signals from
DVDs are also connected here.
1
4. High scan rate sources such as computers
as a pass-through to the projector.
Contrast can be adjusted for this input.
11. HDTV Input from HDTV tuner or tape deck.
OUTPUTS
1
5. D15F connector for use with computer
monitors or to a second display device.
1
6. BNC connectors for main output to display
devices. For YPrPb outputs use:
Red =
Pr
Green =
Y
Blue =
Pb
Note: If HDTV or Computer signals are to be
used, the projector must have separate
H & V sync cables installed.
CONTROL
1
7. 12V trigger to activate automatic
screen relays.
1
8. IR receiver connection allows for use with
external IR receivers so unit can be
installed behind walls.
1
9. RS232 D9F connection for use with RS232
control systems
10. AC Power connection.
1
2
3
4
5
6
7
8
9
10
11
