SETUP
5
Example: A digital projector that has a 4:3 display
chip that locks the aspect ratio when sent the native
resolution and then displayed on a wide angle screen.
Output Format
(Analog)
RGB (Default) /YPrPb
Note: Selecting RGB means connecting the
processor to the display via five wire analog RGBHV.
This function is not active when DVI output is
selected. DVI is always RGBHV.
Composite Sync on H
On/Off (Default)
Note: this function is not active when YPrPb output
is selected
Horizontal Sync Polarity
Negative (Default) / Positive
Changes sync polarity, which may be needed for
compatibility with some displays.
Vertical Sync Polarity
Negative (Default) / Positive
Changes sync polarity, which may be needed for
compatibility with some displays
Note:
Each input on the DVP1000 can be activated
or deactivated to simplify operation so unused inputs
are not accessed when cycling through the inputs
with the remote control.
Set: Video Input
Enabled (Default) /Disabled
Note: Disabling this unused input will remove it from
the input menu list.
Set: S-Video Input
Enabled (Default) /Disabled
Note: Disabling this unused input will remove it from
the input menu list.
Set: RGB Input
Enabled (Default) /Disabled
Note: Disabling this unused input will remove it from
the input menu list.
Set: YCrCb Input
Enabled (Default) /Disabled
Note: Disabling this unused input will remove it from
the input menu list.
Set: DVI Input
Enable / Disable
Note: Disabling this unused input will remove it from
the input menu list.
Set: Passthru Input
Enabled (Default) /Disabled
Note: Disabling this unused input will remove it from
the input menu list.
Set: Passthru Transcode
Disable (Default) /Enable
YPrPb HDTV signals via the D15 input or the YPrPb
(BNC) inputs can be transcoded to RGB when this
feature is enabled.
Set: Component Input Standard
DVD (Default) /Professional (Betacam)
Note: Only use professional setting when using
a device that conforms to SMTPE Betacam levels
Set: RGB Input Sync
Sync-on-Green (Default) /TTL/Video
OSD
(On Screen Display)
On (Default) /Off
OSD Timer
0-255 (30 default)
LCD Timer
6-255 (40 Default)
Note: setting the timer to 5 or lower sets the LCD
backlight to Always On.
Set: RS232 Echo
On (Default) /Off
Allows RSR232 characters to be sent back to
the controller.
Set: Restore Factory
Are You Sure? - Press Enter Key
Use this Function only in the event that
the processor no longer functions properly and
all other system checks have been performed. This
command will erase all custom settings and restore
the original firmware configuration. Be sure to go
back through the Setup procedure for proper
operation.
The next step in the setup procedure is to
align the display device. Be sure to follow
all directions for setting up the display
found in the display’s manual. Using a test
DVD with the Safe Area test pattern, align the image
size, position and blanking first
using the controls found in the display device.
Only use these controls in the DVP1000 if the
display device does not offer these controls or
if there is not enough range.
