- 64 -
1) Safety precautions on Bath remote controller installation.
• Before remote controller installation, check the hole position considering wall stud location.
•
Note
: Do not dismantle the remote controller due to water-proof design.
• Do not install remote controller where water will contact the remote controller directly.
• The remote controller cables carry low voltage, 12VDC digital.
2) Installation of Bath remote controller.
• Drill a hole (more than dia about 1/2" (12mm)) in a wall for the remote controller cables.
• After passing the remote controller cables through the hole, remove the packing’s back paper
of remote controller. Then attach the remote controller to the wall.
• Detach both end covers of remote controller and fix the remote controller to the wall with wood
screws(2 pcs) in the screw holes provided. (You can detach the covers with catching the
bottom corner’s slot with nail.) Do not tighten the screws excessively, as the screw hole may
be damaged. In case of mounting the remote controller on tile, cement or mortar, use an
expansion bolt.
• Reattach the cover and caulk with silicone around surrounding of the remote controller.
Wood screw
Cover
Cover
Expansion bolt
Remote controller cables
BATH REMOTE CONTROLLER YST-2250 (P/N 3749)
Caulking
Bath remote
controller
Caulking
Remote controller
packing
Remote controller
cables
In case of use of store-bought cables.
• The remote controller cable can be extended up to 100' (30m) by splicing the cable and
using 18 gauge wire to extend the cable to the appropriate length.
• Cut the connector of the remote controller lead wire and cut remote controller lead wire and
store-bought cables’ coating in 0.2" (5mm) length.
• Insert the end of remote controller cables to clamping connector and caulk using a caulking
tool.
• Caulk the store-bought cables inserted in the clamping connector using the caulking tool.
Summary of Contents for MWH-180
Page 60: ... 58 WIRING DIAGRAM ...
Page 61: ... 59 WIRING DIAGRAM ...
