GROWSPAN
™
GOTHIC PREMIUM GREENHOUSES
24
106213_14_15_16
Revision date: 06.26.18
Gather Parts:
• 116051 Panels (47-1/4" x 144") & 104774 Vent Tape
• 104213 Aluminum U-channel and 104548 End Cap
Profile
• CG96174 Ridge Cap & DH8007 Foil Tape
• 111929 12' H-channel
• 102921 Neo-Bonded Washers & FA4484B Tek Screws
ATTENTION:
DO NOT store or allow polycarbonate panels
to remain in direct sunlight for an extended period of time
before installation.
Doing so could cause protective film
to become difficult if not impossible to remove.
INSTALL ROOF PANELS: OVERVIEW
Install polycarbonate roof panels after installing end panels. These are the main steps to attach panels:
1. Prepare and install lower panels first along both sides for first two (2) bays (as shown).
2. Install upper panel for end bay. (Upper panel overlaps lower panel by six (6) inches.)
3. Install ridge cap.
4. Repeating Steps 1–3, work toward other end of frame until all panels and ridge cap sections are installed.
5. Attach aluminum profile to lower edge of upper panel and secure using Tek screws and washers.
6. Seal panels and profile.
7. Continue with baseboard installation if used.
ASSEMBLY NOTE:
Install Tek screws using a clutched
drill driver running approximately 750 RPM while applying
approximately 50 lbs of force.
Do not use an impact driver to install Tek screws!
INSTALL POLYCARBONATE ROOF PANELS
The diagram that follows shows locations of different
panels. Frame shown below may differ from actual frame.
NOTE:
Install so upper panels overlap top edge of lower
panels
approximately six (6) inches.
Ridge Cap (CG96174)
Upper Panels: Use one (1) 47-1/4" x 144"
panel (116051) to create two (2) upper
panels.
Lower Panels (both sides):
Full 47-1/4" x 144" Panels –
all building widths and lengths.
(116051)
6" Panel Overlap —
Both Sides
NOTE:
Dashed line shows tops
of lower panels; solid line shows
bottom of upper panels.
