GROWSPAN
™
GOTHIC PREMIUM GREENHOUSES
20
106213_14_15_16
Revision date: 06.26.18
Complete following general steps to install end wall panels.
1. Consult panel location diagrams, select one 4' x 12'
polycarbonate panel, begin at edge of door opening,
and work to the outside edge of end wall.
END PANEL INSTALLATION (continued)
Mark UV Side
X
Dashed line and arrows show where to install white
vent tape.
NOTE:
Remove protective film. When needed, panels
are cut to length
after
they are attached to end wall
frame and rafter. See photo on next page.
3. Measure, cut Panel A, and place in position. Add
H-channel along outer edge and U-profile along door.
4. Attach to end wall framing using long Tek screws
(FA4484B).
Install H-channel with flat side out.
NOTE:
Consult end wall diagrams located in Quick
Start section for on-center dimensions.
Remember to
account for installation of H-channel.
Space screws evenly
at 16"
when securing panels.
DO NOT USE WASHERS WHEN SECURING
H-CHANNEL TO END WALL FRAMING.
Remainder of 4' x 12' panel
is used to cover area
along other side of door.
Always remove protective film
and mark and install UV-protected side to outside of
greenhouse.
2. Apply white vent tape to bottom of panel. Review
diagram in right column for aluminum profile (104213)
placement along edge adjacent to door. See also
Polycarbonate Panels diagram in Quick Start section.
Cut from a
4' x 12' Panel
Not to scale.
A
104213 u-profile
here along door
edge.
A
H-channel here –
outer edge of panel.
H-channel here
above door.
Ground Level
A
