10
Revision date: 03.08.17
End Wall Power Vent
ASSEMBLE VENT FRAME
Depending on length of purchased shelter, vent frame may consist of longer components different dimensions. All
applications in all diagrams are the same. Adjust accordingly.
NOTE:
To prevent damage to frame components,
it is best to assemble the frame in short sections.
Assembled
frame sections can then be added to the building and connected. Assemble on a flat, covered surface to protect
components. With assistance, hang each section on the building. The procedures in the following pages shows the
assembly of a 4'W x 8'L sample panel section.
Use the steps that follow as guides when assembling your vent system.
1. Locate the vent sash (111614Z144) for the vent and attach these to the building.
ATTENTION:
Lip on the backside of vent sash will align with the bottom edge of
the opening cut out in a previous step.
Consult installation details on the following page.
Vent Sash (111614Z144)
White dashed line
indicates installation
location of the
11614Z144 vent sash.
1.5"x1.5"
Cross
Beam
Vent sash
installed on
top of the
polycarbonate.
Set vent sash
lip under
previously cut
polycarbonate
edge as shown.
FA4484B
Tek screw
&
102921B
neo-bonded
washer
2"x2"
End Wall
Column
Polycarbonate
Cladding
CUT-AWAY SIDE VIEWS
111614Z144
Vent Sash
