66
115554 Revision date: 01.27.20
4
Install Bulkhead Fittings
INSTALL BULKHEAD FITTINGS
System is equipped with two (2) 111301 bulkhead fittings which are used to connect the tray to the lower reservoir.
Gather these parts and install the fittings:
• 111301 Bulkhead fittings (2)
1
3
4
2
1. Flip tray over so inside is facing
up and center tray on frame.
2. Take one 111301 bulkhead fitting
and verify that the fitting includes
a washer.
3. Insert the fitting with washer
through one of the holes.
4. Seat fitting tightly in the hole.
6
5
7
5. Take the bulkhead nut and turn it
onto the threaded shaft.
Tighten
until fitting is snug.
NOTE:
Use a large pair of
adjustable pliers if necessary.
Do
not overtighten the nut!
6. Repeat the steps to install the
remaining bulkhead fitting.
NOTE:
Check both fitting nuts to
ensure each is tight.
7. Inspect the assembled fittings to
ensure that a washer is present
on the inside between each fitting
and the tray.
8. Continue with the next procedure.
Washer
