![background image](http://html1.mh-extra.com/html/farmtek/clearview-105658/clearview-105658_quick-start-manual_545481005.webp)
CLEARVIEW
™
PANELS
Visit
www.ClearSpan.com
for additional products and customer assistance.
Attach the sides of the panel using screws with
washers for a more permanent installation.
NOTE:
If the frame is metal, use a self-drilling Tek
screw with a fender washer. If the frame is wood, use
a non-corrosive wood or decking screw with a non-
corrosive flat washer.
5.
HANG THE PANEL USING SCREWS AND WASHERS
Gather the Tools and Materials
Variable speed drill or screwdriver
3/8'' Nut Setter or 3/8'' socket
Tek screws or non-corrosive wood screws
Fender washers or 1/4'' non-corrosive flat washers
Snugger tie-downs
•
•
•
•
•
With the help of an assistant hold the panel along the
straight line where the grommets will be located.
Insert a screw with a washer, through the grommet in
either upper corner of the panel, into the frame.
NOTE:
If the frame is metal, use a self-drilling Tek
screw with a fender washer. If the frame is wood, use
a non-corrosive wood or decking screw with a non-
corrosive flat washer.
1.
2.
Attach the sides of the panel to the frame using screws
with washers if you want a more permanent installation.
6.
To remove fine dust from the panel, spray a liquid
window cleaner on it and wipe with a soft cloth. Do not
wipe the panel with a dry cloth.
To reduce static electricity in the panel, lightly wipe it
with a clothes dryer anti-static sheet.
To remove mud or dirt from the panel, spray it with
water from a garden hose and wipe with a soft cloth.
Secure the panel to the frame if high winds are
expected.
To store the panel when not needed, roll it rather
than fold it to prevent permanent wrinkles in the clear
material.
Do not store the panel if it is wet. Allow it to air-dry
before storage.
•
•
•
•
•
•
CARE AND MAINTENANCE
Your ClearView™ panel will provide years of trouble-free
service. To protect your investment follow the tips below.
Hold the panel tight and insert a screw with a washer
into the opposite upper corner of the panel.
Hold the panel straight along the top and insert screws
with washers in every grommet.
3.
4.
Attach the sides of the panel to the frame using
snugger tie-downs if you want to remove the panel
periodically.
5.
The bottom of the panel may be attached to a deck
railing, the floor, or a 2'' x 4'' screwed to the floor. Attach
the bottom of the panel using screws and washers at
least every 24''.
6.
The bottom of the panel may be attached to a deck
railing, the floor, or a 2'' x 4'' screwed to the floor. Attach
the bottom of the panel using screws and washers at
least every 24''.
7.