Visit
www.ClearSpan.com
for additional products and customer assistance.
CLEARVIEW
™
PANELS
ClearView
™
Panel
PREPARE THE FRAME
Gather the Tools and Materials
Drill bit
Variable speed drill or screwdriver
•
•
With the help of an assistant, hold the panel centered
on the outside of the frame.
Mark the frame where each grommet will be located.
Draw a straight line between the first and last marks on
the frame. This assures the panel hangs straight and
does not sag in the middle.
NOTE:
The panel can be hung from the frame using
screw hooks if you want to remove it periodically, or
screws with washers if you want it more permanently
mounted.
Proceed to the section covering the method of
installation chosen.
1.
2.
3.
4.
HANG THE PANEL USING SCREW HOOKS
Gather the Tools and Materials
Screw hooks
Drill bit
Variable speed drill
Snugger tie-downs
Tek screws
Fender washers
•
•
•
•
•
•
Drill pilot holes along the straight line where the
grommets will be located and insert a screw hook into
each hole.
Drive the screw hooks into the frame to the same depth
along the straight line so the panel will hang evenly.
Turn the open side of the hooks upward.
Hang the panel on the screw hooks by slipping the
grommets over the open end of the hooks.
1.
2.
3.
Attach the sides of the panel to the frame using
snugger tie-downs if you want to remove the panel
periodically.
4.
