6
112529 Revision date: 05.13.20
Assembly Instructions
2
Complete these steps:
1. Locate and mark the center at each end of the frame.
2. Center the WF4140 tube on the mark and place the
FAPA14 pipe clamp over the tube. Align the pipe clamp
with the outside edge of the frame to prevent conflicts
with the Dutch bucket at each end.
3. Hold the assembly steady and mark the bolt hole
locations on the top of the end frame support.
4. Using a drill and 5/16" bit, drill the two (2) mounting
holes for the clamp.
5. Take the 1/4" fasteners and attach the clamp. Do not
fully tighten these bolts at this time. PVC tube should
slide into the clamp.
6. Move to the opposite end of the frame and repeat the
steps to install that clamp.
7. Finally, install the center pipe clamp using the above
steps as a guide. Center this clamp on the frame
member.
8. Continue with the next procedure.
INSTALL 1-1/2" DRAIN TUBE CLAMPS
Locate and
mark center
of frame at
each end.
STEP 1
Align center of
tube with center
of frame.
STEPS 2 & 3
STEP 4
STEP 5
Drain T
ube
STEP 7
Required Parts:
• WF4140 PVC tube (1) and FAPA14 pipe clamp
for 1-1/2" PVC
• FAG102B 1/4" x 3/4" bolts (6) and FALF15B
1/4" lock nuts (6)
