10
10
Revision date: 08.26.15
INSTALL LONG BENCH TOP SUPPORT TUBES
Assembly Instructions
4
1. At all crossbars, measure 9-1/2" in from the
brackets and mark the location.
4. Take a 112431 angle clip and place it in
position against the crossbar and under the
support.
NOTE:
Use a piece of tape (not included) to
hold the clip in place.
To prevent injury, do
not hold with fingers.
2. Set tubes on the crossbars and adjust the
position so the pipes extend an equal length
beyond crossbar at each end.
5. Drive a Tek screw into the crossbar to secure
the clip.
3. Align the center of one tube with mark and
clamp. Recheck the position.
• (2) 1.25" x 1.25" square tubes (See Quick Start section for ID.)
• 112431 aluminum angle clips (Bench length determines quantity.)
6. Remove the tape if used and leave clamp in
place.
