F a r m T e k ®
3
Once all 102676 ground posts are in place and plumb, take a drilled corner post and slide one (1)
4.
105968 90° corner swivel onto the post. Position the set screws of the swivel up and toward the
top of the corner post. Using a 5/16" hex key wrench, temporarily secure the swivel to the corner
post to prevent it from sliding off when you set the post onto the ground post.
With assistance and with the swivel secured to the drilled corner post, slide the post over the
5.
top of one ground post, align the mounting holes, and secure the corner post to the ground post
using two (2) 5/16" bolts, washers, and nuts.
If the holes do not align to allow the bolt to pass
through, use a drill and drill bit to enlarge as needed.
Measure 24" down from the top of the corner post and mark the location as shown in the photo to
6.
the right. This will be the position of the swivel once the remaining pipes are attached.
Take the remaining two (2) 1.90" x 120" plain pipes, slide each into one of the remaining sockets
7.
of the swivel, and tighten the set screws to secure the pipes.
With assistance, hold the swivel and pipe assembly and loosen the main set screw holding
8.
the swivel to the ground post. You should be able to slide the assembly up and down the post.
Position the diagonal legs of the corner post assembly to the inside to the fenced area.
Slide the assembly until the top of the swivel is aligned with the 24" mark on the post and
9.
tighten the set screw. Push the free end of each diagonal pipe into the site to keep in position.
Depending on the site, adjust the height of the swivel as needed to set the diagonal legs into the
ground. Verify that the corner post is straight before you set the diagonal posts into the site.
Repeat the procedures as needed to assembly any remaining corner posts and install the fence.
10.
24"
120" Pipe
Corner Post
Step 4
102676
Ground Post
190P120
Corner Post
5/16" x 3-1/2"
Carriage Bolts
5/16" Nuts
5/16"
Flat Washers
Step 5
Step 7
120" Pipe
