CARTS AND WAGONS
5
Revision date: 10.22.08
3. Attach the steering arm to the front axle assembly by
sliding the upper arm over the stud on the underside of
the axle assembly.
View shows the underside of the axle assembly.
4. Install the steering pivot washer on the stud, insert the
cotter pin through the hole in the stud, and spread the
legs of the cotter pin to secure the connection.
5. Insert an 6 x 17mm shoulder bolt through the center
hole in the tie strap and the rear hole in the steering
arm, install an M6 flat washer and M6 locknut on the
shoulder bolt, and tighten the nut. See circle below.
INSTALL FRONT AXLE
1. Turn the wagon on its side to install the front axle
assembly.
6. Attach the front axle brace to the front axle assembly
by inserting a 6 x 20mm shoulder bolt through the front
axle brace, front axle assembly, and steering arm.
NOTE:
To prevent binding,
ensure the large part of the
shoulder bolt goes through the
tie strap and the steering arm
before the nut is tightened.
7. Install an M6 flat washer and M6 locknut on the
shoulder bolt and tighten the nut.
NOTE:
To prevent binding, ensure the large part of
the shoulder bolt goes through the holes in the front
axle brace, steering arm, and axle assembly before
tightening the locknut.
8. Continue by attaching the front axle assembly to the
wagon bed.
NOTE:
An assistant can help to steady the bed during
this installation if needed.
Steering Arm
Steering Pivot
Flat Washer
Stud
Cotter Pin
Upper Arm
View shows the
underside of the
axle assembly.
ASSEMBLE FRONT AXLE (CONTINUED)
Shoulder Bolt
Front Axle
Brace
Steering Arm
Front Axle Assembly
