AM-Jackal-2
more quick guides @ www.farmscanag.com/jackal
July 2013
9
Area & Speed Meter Setup (Wizard)
AREA & SPEED METER SETUP (WIZARD)
DESCRIPTION
The Jackal can display Speed & Area in any combination of km/mph or ha/acre.
A pickup can be mounted either on a wheel hub or shaft.
SENSORS REQUIRED
Wheel sensor pickup 2 or 3 wire
Magnet (Used with 2 wire sensor)
AVAILABLE CONNECTIONS (REFER PAGE 3)
This setup section assumes that physical wiring for the required sensors have been completed. If not please
refer to page 3 on wiring requirements
SETUP
FRONT SCREEN>SETUP>WIZARD>AREA/SPEED WHEEL
1.
Using the
NAV KEYS
select the current port the wheel sensor input is connected to & press NEXT
2.
Press
EDIT
(to enable the port)
3.
Using the
EDIT KEY
select your unit of pulse for calibration
M (Meter) | ft. (Feet) | yd.(Yard) | in (Inch) | km (Kilometer) | mi (Miles)
CALIBRATION
Ensure that the sensor & pickup are end-end before continuing with either method
Mark bottom centre of tyre on which the sensor is fitted and peg ground in corresponding position
CHOOSE CALIBRATION METHOD OF TARGET OR MANUAL RATIO AS DESCRIBED BELOW:
OPTION 1 : TARGET METHOD
1.
Measure out a known distance to calibrate i.e. 20m to use the auto calibrate function.
o
Peg the 2 corresponding points.
2.
Enter the target distance by pressing the
EDIT
key i.e. 20
3.
Press
EXIT
when done
4.
Press the
START
button and move slowly forward to allow pulses to register.
5.
When you arrive at the centre mark point of tyre to peg press
STOP
6.
Press
CALC
OPTION 2 : MANUAL RATIO
1.
Enter a known wheel factor (i.e. Wheel circumference)
2.
Scroll down to the Manual Ratio (1.000000) and press the
EDIT
Enter the known wheel factor
3.
Press
EXIT
when done
4.
Select
NEXT
5.
Enter your implement Width
EDIT
in desired UOM (M,FT,YD,IN,KM,MI)
This will show covered area on the main screen
6.
Scroll down to enable/disable the External/Run hold
(Refer page 3 for inputs)
7.
If the External/Run Hold is enable select the input port to where it is connected
Summary of Contents for Jackal v2
Page 1: ......
