Farmi 381 HFC, Operation, Maintenance And Spare Parts Manual

Page: 18 / 72

FARMI 381 HFC / HF
18
MOUNTING
LIFTING
The lifting points are marked on
each machine with hook sym-
bols.
Only use appropriate lifting equipment of sufficient
lifting capacity to lift the equipment.
Lifting belts, cables and chains used for lifting must be
checked regularly.
The weight of the load to be lifted must be known.
Never exceed the lifting capacity limit specified by the
lifting device manufacturer.
Avoid lifting equipment over areas where people may
be present.
MOUNTING
• Attach the chipper to the tractor’s 3-point hitch.
• When handling the chipper, ensure that it is coup-
led to the 3-point hitch.
• Check that the power take-off (PTO) drive shaft is
the correct length. For details on shortening the
PTO shaft see the Power Take-Off Shaft” section.
• Check that the PTO shaft shields are in place and
the shield rotation prevention chain is attached.
POWER TAKE-OFF SHAFT
Tractor’s PTO drive shaft
dimensions should be 1 3/4” to
maximize its operating life.
PTO shaft recommendations:
• Bondioli & Pavesi 10 (106 kW / 540 rpm) with over-
running clutch
• Walterscheid W2600 + F3 with overrunning clutch
An overrunning clutch must be mounted to the axle
head on the chipper’s power take-off.
If the PTO shaft is too long it
might damage chipper’s bea-
rings or the tractor’s power take-
off shaft when using the 3-point
hitch . Shorten the both ends of
PTO shaft equaly.
CAUTION!
!
CAUTION!
!
CAUTION!
!