22
CH180 Avant
Connecting the multiconnector system:
Connecting the multiconnector system:
1.
Align the pins of the attachment connector with
corresponding holes of the loader connector. The
multiconnector will not connect if the attachment
connector is upside down.
2.
Connect and lock the multiconnector by turning the
lever towards the loader.
The lever should move easily all the way to its locking position. If the lever does not slide smoothly, check the
alignment and position of the connector and clean the connectors. Also shut down the loader and release the
residual hydraulic pressure
To disconnect the multiconnector system:
Before disconnecting put the attachment down on a solid
and even surface
3.
Switch off the auxiliary hydraulics of the loader.
4.
While pushing unlock button, turn the lever to
disconnect the connector.
5.
After ending operation put the multiconnector on its
holder on the attachment.
Disconnecting hydraulic hoses:
Before disconnecting the fittings, lower the attachment to safe position on solid and level surface. Turn the control
lever of the auxiliary hydraulics to its neutral position.
NOTICE!
When uncoupling the attachment, always disconnect the hydraulic couplings before
unlocking the quick coupling plate, to prevent hose damage and any oil spills. Reinstall the
protective caps on the fittings to prevent impurities from entering the hydraulic system.
Releasing residual hydraulic pressure:
In case residual pressure is left in the hydraulic system of the attachment, it is often possible to disconnect the
hydraulic couplings, but it may be difficult to connect them the next time. If the fittings will not connect, the
residual pressure must be released by turning the auxiliary hydraulics control lever of the loader, when the engine is
turned off. To make sure that there will not be residual pressure in the hydraulic system of the attachment, shut
down the loader engine and move the auxiliary hydraulics control lever of the loader back and forth before
disconnecting the couplings.
ELECTRIC CONNECTION
Electric functions of the attachment:
Electric power to the adjustment can be supplied with the optional Attachment control switch pack of the loader,
or with the standard electric harness that is supplied with the attachment.
To connect the electric harness of the attachment to the loader
Starting form year 2016, there is an integrated electric plug in the multiconnector of the attachment. However,
a separate electric harness is also supplied with the attachment, to make it possible to connect and use the
attachment with loaders that are not equipped with Attachment control switch pack.
There are three ways to connect the electric connector, depending on the equipment on the loader and the
attachment:
Summary of Contents for CH180 AVANT
Page 2: ......
Page 4: ......
Page 35: ...CH180 Avant 35 Farmi Forest Kilpivirrantie 7 74120 IISALMI FINLAND ...
