Manual
VIDIUM P 350 | P 450
11
│
24
CONNECTING THE PLOUGH TO THE TRACTOR
Connect the plough in the working or transport position to the tractor in the following way:
The diameter of the connecting axle (pin diameter) must be 36 mm!
The hydraulic equipment of the tractor must be switched to position regulation.
Connect the bottom drawbar with the connecting axle of the plough and secure it with a safety pin.
Lift the connecting body using the bottom drawbar.
Release the chain from the cross joint.
Tip the bottom drawbar until the top drawbar matches the top opening of the body to be connected.
Mount the top drawbar of the tractor to the connecting body using the connecting pin and secure it with a
safety pin. The length of the top drawbar should be selected so that the connected body and the towing fork
are horizontal.
Lift the bottom drawbar.
Release the support, move it up and arrest it.
Mount hydraulic hoses to the control equipment of the tractor.
Remove the Scotch blocks.
The hydraulic equipment must be switched on using the tractive force or mixed regulation in order to work
with the plough. Observe the operating manual of the producer of the tractor.
DISCONNECTING THE PLOUGH
Switch the hydraulic equipment into the position regulation.
Turn the frame of the plough into the transport position and close the ball valves on the stripper.
Close the stop valves for the rotating element or for the wheel spacing adjustment.
Position the plough on solid and even ground.
Release the support, move it down and arrest it.
Lower down the chassis completely (until the impact spindles on the wheel forks are lifted) and close the
stop valve for lifting hydraulics.
Secure the chassis with Scotch blocks to prevent movement!
Lower down the bottom drawbar until the top drawbar can move freely.
Remove the top drawbar from the connected body and lift the bottom drawbar.
Hang the safety chain on the cross joint and lower the bottom drawbar.
Disconnect the bottom drawbar from the connecting axle.
Depressurize the hydraulic equipment of the tractor.
Switch off the engine.
Disconnect the hydraulic hoses from the tractor and mount the dust covers.
When connecting the machine, there must not be any people in the area between the machine
and the tractor
.
3.2.CONNECTING THE HYDRAULICS
Connect the hydraulics only if the hydraulic circuits of the machine and the tractor (aggregate) are without
any pressure.
The hydraulic system is under great pressure. Check regularly for leakages and immediately eliminate any
visible damage to all distribution, tubes and screw joints.
Use appropriate equipment when checking for and eliminating leakages.
Use the plug (on the machine) and the socket (on the tractor) of the same type of snap coupling when
connecting the hydraulic system of the machine to the tractor. Connect the snap couplings of the machine
to the hydraulic circuits of the tractor so that the plough rotation is on one control circuit and the plough
lifting on the axle is on another control circuit.
In order to rule out unintentional movement of the hydraulics or movement caused
by third persons (children, passengers), the controlling distributors in the tractor
must be secured or blocked and the controlling unit switched off if the machine is
not used or if it is in the transport position
.
