Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
30
│
56
RELEASE THE POSITION OF THE TRANSPORT AXLE …K500-700PS
o
When unfolding into the working position is complete, the ball valve of the piston-rod must be released
from the transport position to the “open” position.
RELEASE THE POSITION OF THE TRANSPORT AXLE …K800-1000PS
o
When unfolding into the working position is complete, the machine must be lifted from the axle backstop
by pressurizing the hydraulic circuit marked with two yellow rings. Then, release the axle from the
transport position by flipping the backstop. Secure the backstop with a pin so that it cannot come loose.
Then, release the axle control circuit (MARKED WITH YELLOW RINGS) from the driver’s position into the
floating position to lower the machine down to the end, thus achieving the
transport position of 4m.
PLACE THE MACHINE ON THE WORKING ROLLERS
o
Lower the machine down to the ground by pressurizing the hydraulic circuit marked with one yellow
ring. Continue until the piston-rod is completely drawn in and the travelling wheels are lifted above the
ground. The machine is standing on its working parts (rollers or shares). At the same time, lower the rear
arms of the tractor, if the machine is aggregated in this way. If the machine is aggregated to the fixed
bottom hitch of the tractor, the machine is lifted automatically with the axle. If the machine is
aggregated to the fixed bottom hitch of the tractor, the machine is lowered automatically with the axle
control.
o
Block or close the circuits.
BALL VALVE
OPEN
