Farm King BW150, Operator And Parts Manual

Page: 29 / 74

Operation - BW150
29
WRAPPER OPERATION
Installing Film
NOTE: With each revolution of the rotating frame, the
bale and film rotate by a certain angle around
the horizontal axis, which causes the
consecutive layers of film to be wrapped
tightly around the bale.
Figure 8
NOTE: When installing the roll of film, place its
internal, sticky side towards the bale axis.
Route the film (Item 1) over roller pin (Item 2) and under
roller pin (Item 3)
[Figure 8] .
Figure 9
Move the support (Item 1) away from the metal rollers
and secure it by using the hook (Item 2)
[Figure 9]
attached to the wrapping assembly.
Turn lever (Item 3) [Figure 9] counterclockwise until
there is adequate space to install the film roll.
Adjust the height of the lower pin (Item 4) [Figure 9] in
position appropriate for the desired film roll width (500
mm or 750 mm).
Place the film roll (Item 5) on the lower conic pin (Item 6)
[Figure 9] .
Turn lever (Item 3) [Figure 9] clockwise until the roll is
securely held in the vertical position.
Prevent the film roll from unscrewing by tightening the nut
(Item 7)
[Figure 9] on the crank screw.
Pull the film through the rollers as shown on the diagram
[Figure 8] .
NOTE: Pull the end of the film so that it may be easily
handled in the machine.
ENTANGLEMENT HAZARD
• Clear the work area of all bystanders, especially
small children and animals.
• Disconnect hydraulic hose before working on
the machine.
• Keep shields and all guards in place.
• Keep away from moving parts.
BW-008
1
2
3
FILM ROUTING DIAGRAM
BW-009
1
2
3
4
5
6
7