Operation - Hydraulic Series
39
Pre - Operation Checklist
Before operating the snowblower for the first time
and each time thereafter, check the following items:
1. Lubricate the equipment per the schedule outline in
the Maintenance Section.
2. Check the snowblower hitch for damaged, loose or
missing parts. Repair as needed before operation.
Note: Do not operate with leaks.
3. Make sure that all guards and shields are in place,
secured and functioning as designed.
4. Check condition of all hydraulic components for
leaks. Repair as required.
5. Check that all electrical connections are tight.
6. Check the augers. Remove any twine, wire or other
material that has become entangled.
WARNING
HIGH PRESSURE FLUID HAZARD
Leaking fluids under pressure can enter the skin
and cause serious injury or death. Immediate
medical attention is required. Wear goggles. Use
cardboard to check for leaks.
Note: Do not operate with hydraulic leaks.
Entering The Operator’s Position
Enter the operator’s position, start the engine, and
release the parking brake.
IMPORTANT
Follow the instructions in your tractor’s operation
manual for the correct procedure.
Leaving The Operator’s Position
Always perform the following steps when leaving
the operator’s position:
WARNING
AVOID INJURY OR DEATH
Before you leave the operator’s position:
• Always park on a flat level surface.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Stop the engine and remove the key.
• Wait for all moving parts to stop.
Tractor Requirements
The tractor must satisfy the following requirements,
depending on model.
Summary of Contents for Allied 6025
