Farm King 1684, Operator And Parts Manual, Page: 62 / 158

Maintenance - 1684, 16104, 16124 Backsaver Auger
60
BRIDGING
Cable Inspection
IMPORTANT
Always wear the proper hand and eye protection
when serving the equipment.
Regularly check the tightness of all cable clamps
to avoid slipping. Inspect cables regularly for
damage, wear or corrosion.
Cable inspections should be done at the beginning
of operation and directly after the auger has been
towed or transported.
Use a piece of cloth or rag to slide across the
cables to locate broken or frayed wires. Replace
cables as needed.
Lubrication
To prevent damage by corrosion, the cables should
be kept well lubricated.
Cleaning
Periodic cleaning of cables by using a stiff brush
and kerosene or with compressed air or live steam
and re-lubricating will help to lengthen cable life
and reduce abrasion and wear on sheaves and
drums.
Cable Tension Adjustment
Check cable tension weekly or EVERY 50 HOURS :
IMPORTANT
Completely unload auger before adjusting
bridging cables.
Figure 55
Install a strap (Item 1) around the tube [Figure 55] .
Connect the strap to an approved lifting device.
Raise the lifting device, until tight, to support the
auger tube(s).
WARNING
AVOID INJURY OR DEATH
Before you leave the operator’s position:
•
Always park on a flat level surface.
• Fully lower the main auger into the transport
position.
•
Disconnect the PTO driveline.
• Support the main auger tube with an approved
lifting device.
•
Chock tires.
1