Farm King 1684, Operator And Parts Manual, Page: 43 / 158

Operation - 1684, 16104, 16124 Backsaver Auger
41
Unloading Rear And Side Dump Units
Figure 25
Move the hopper out at a 90° angle from the auger.
Move the rear dump unit into the unloading
position at the end of the hopper (Item 1) or on
the tractor side of the hopper (Item 2)
[Figure 25] .
Move the side dump unit into the unloading
position at the end of the hopper (Item 1)
[Figure
25].
Position the gate of the dumping unit over the
hopper (as close to the center of the hopper as
possible).
Stop the dumping unit and engage the parking
brake (if equipped).
WARNING
AVOID INJURY OR DEATH
Do NOT exceed 1000 RPM PTO.
Keep PTO shields and all guards in place.
Keep away from moving parts.
Keep bystanders away.
With tractor running at a low idle, engage the
tractor PTO slowly to start the auger. Increase
engine RPM (do not exceed 1000 RPM speed).
Slowly open the gate on the dumping unit.
Adjust gate until the hopper augers and intake
auger can move grain to the main auger without
overflowing the hopper.
When the unit is empty, close the gate, disengage
the PTO and lower engine RPM speed.
Disengage the tractor hydraulics and exit the
tractor.
1
2