Fargo Fargo HDP8500, Service Manual

Page: 118 / 141

HDP8500 Service Manual, PLT-01583, 1.1
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
118
Remove/Replace the Rewind Motor (D900406) Gear (D920170)
Tools needed: Small flathead screwdriver; a hook tool for
O-Ring.
Estimated Time: 30 minutes
Preparation: Remove the Covers
Important: This procedure can only be performed by
authorized service personnel.
Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the Printer.
2 Remove the Covers.
3 Disconnect the cable (D920153) from the top of the Motor.
4
Disconnect the wire bundle from the holding clip. ( Note: Observe how the wires are routed.)
5 Disconnect the Encoder Sensor cable (D920147) from the Encoder Sensor Board (A000126).
( Note: This cable is located toward the bottom of the Rewind Mount.)
Unsnap the Encoder Sensor (A000126) from the Rewind Motor Frame. ( Note: This will
make it easier for reassembly.)

See the display on the next page.
6 Unclip the Rewind Mount from the top. ( Note: The top tab must be lifted slightly to release
the Motor Frame.)
Be careful NOT to bend the metal Encoder wheel. ( Note: The Encoder Sensor must clear
the Encoder Wheel when removing it.)

See the display on the next page.