Fargo Fargo HDP8500, Service Manual

Page: 108 / 141

HDP8500 Service Manual, PLT-01583, 1.1
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
108
Remove/Replace the Film Mark Sensor (D920155) Upper and Lower
Tools needed: Needle Nose Pliers
Estimated Time: 30 minutes
Preparation: Remove the Covers.
Important: This procedure can only be performed by authorized service
personnel.
D920155 is located on the CenterPlate Exit D920027
Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the Printer.
2 Remove the Covers.
3 Disconnect the cable (D920155) from the Main Board at location J26 for the lower Sensor and
J27 for the upper Sensor.
4 Remove the Upper and Lower Take-Up Motors for clearance to access the Sensors. See
Replacing the Take-up Motor (D920118) .
5 For the Upper Sensor remove the metal Roller (D920137) by snapping it up and out from the
front side Frame peg hole. ( Note: Use needle nose pliers to grab the Sensor/cable and pull it
out.)