Mi 2348
- 5 -
To set relay 2:
4) present the card to the reader; you hear the warning beep, the
display shows
00
for about 1 second, then the display on the left
shows
2
followed by 01 in the two displays on the right. 01
progressively increases up to
63
;
5) remove the card when the display shows the correct activation time;
6) to exit the programming mode, wait until the
and
LED’s turn
off or present the Master card to the reader and remove it when the
display shows
00
.
To modify incorrect entries you must repeat the operations illustrated
above.
After you programme Master cards and relay activation time, you can
install the reader on the wall and carry out the next operations on the
front panel.
USER SETTING
To code, cancel or select the relay, present the
Master card
to the
reader to access the user setting mode. You hear the confirmation
beep. The
LED flashes and the display shows the following codes
in sequence:
A00
exit from setup
A01
access to “user card coding”
A02
access to “user card cancellation”
Remove the card when the display shows the preferred mode.
How to code user cards
The
LED turns ON after you select mode
A01
(see section above).
To activate relay 1 only
(default setting) go to step 3. Otherwise select
the preferred mode as illustrated below:
1) present the Master card to the reader; the display shows the following
codes in sequence:
00
exit from setup
01
activation of relay 1
02
activation of relay 2
03
simultaneous activation of relay 1 and 2
2) Remove the card when the display shows the preferred mode (
00
,
01
,
02
or
03
).
3) Present the first user card to the reader. You hear the confirmation
beep. The display shows
011
. Remove the card. Present all cards
to be programmed with the same operation mode to the reader.
Cards have progressive numbers (011, 012, 013, etc.). The numbers
of cards that you have programmed and then cancelled are re-used.
Note
. If some user cards must be programmed to activate the relay
in a different mode, you must repeat the operations starting from step
1.
4) After you complete the operation, present the
Master card
to the
reader to exit the programming mode and remove it when the display
shows
00
.
Important
. Write down the card number and the user name in order
to cancel it if the card is lost or stolen.
How to cancel user cards
Present the
Master card
to the reader and remove it when the display
shows
A02
. The
LED turns on.
Present the first card to be cancelled to the reader. You hear the
confirmation beep and the display shows the number associated with
the user card for 1 second. Remove the card.
To cancel more cards, you simply need to present them to the reader.
After you complete the operation, wait until the
LED turns off to exit
the cancellation mode. Or present the
Master card
to the reader and
remove it. Repeat the operation 3 times until the display shows
000
.
Present the Master card to the reader again to confirm exit from
cancellation mode.
Example: how to cancel card
11
.
Example 1: how to code the card
with number
11
to activate relay
1 only (default setting).
Example: how to code the card with number
12
to activate relay 2 only.
5
20
04
2
2
03
2
0
2 2
M
AS
TE
R
M
AST
ER
0
2
1
00
00
MASTER
MASTER
0 2
0 1
0
0
0
A
A
1
M
AS
TE
R
M
AS
TE
R
MA
ST
ER
M
AS
TE
R
0
0