8
FILLING THE WATER TANK
1. Unplug the Iron before filling.
2. Turn the Variable Steam Dial to NO STEAM
setting.
3. Hold the Iron upright but slightly tipped..
4. Using a measuring cup, slowly pour water
into the Water Tank Opening.
5. Check see-through Water Tank to see if Iron
is filled to Maximum Fill Line.
NOTE:
Your Iron is designed to use tap water.
However, if your water is very hard, it is
recommended that you use distilled water. DO NOT use water
from home water softening systems because such water may
contain minerals that may harm the Iron.
EMPTYING THE WATER TANK
The Water Tank should be emptied after each use.
1. Position Temperature Control Dial to the lowest MIN setting.
Unplug Iron from the electrical outlet.
2. While the Iron is still warm, hold the Iron over a sink and allow
the Iron to drain by tipping the point of the Iron down.
3. Gently shake the Iron to loosen any water drops that may
be trapped. The warmth of the Iron should dry out any
remaining water.
NOTE:
If you empty the Water Tank after the Iron has cooled, set
the Iron in an upright position on its Heel. Plug it in and set the
Temperature Control Dial to MAXIMUM heat for 2 minutes.
Then unplug the Iron and let it cool before storing.
AUTOMATIC SAFETY SHUT-OFF
As a built-in safety measure, the Iron is programmed to shut-off
automatically after 45 minutes. When the Iron shuts itself off, the
Reset Button, located on the Top of the Iron Handle will go out. If
you wish to resume ironing, simply push the Reset Button. The
Light will illuminate and the Iron will re-energize immediately.
