ENGLISH
11
OPERATING INSTRUCTIONS
BEFORE WASHING
Make sure both the water inlet and drain hoses are installed properly and the end of
the drain hose is in a secured draining spot (instructions above). Once unit is plugged
in, make sure you place the wash load into the tub evenly. Mix large and small articles
of clothing to get the best washing results. Drop articles loosely into the inner tub.
Clothing should move freely through the washer for best cleaning results.
When washing very large articles, do not fill inner tub as full as with other loads.
The water level in your washer should fit the size of your wash load. Small loads
will use lower water levels. There must be enough water in the inner tub to allow
articles to move and turn over freely. Overloading the inner tub can result in poor
washing and rinsing. Overloading may also cause wrinkling and tearing.
HOW TO START A CYCLE
To select one of the pre-programmed automatic wash
cycles, follow the instructions as shown below:
1.
Turn on the water supply.
2.
Pour laundry detergent in the laundry dispensing
hole (on top of tub, see picture).
3.
Close the lid.
NOTE
: Lid must be closed in order to start a cycle.
4.
Press the power button.
5.
Press program button to select program until the indicator light is ON. (Heavy is default).
6.
Press the water level button to select the appropriate water
level setting (Can choose between 1-6. Default is 3).
7.
Press the Start/Pause to start the cycle. LED display will
show the remaining time left of the cycle.
NOTE
: In the event the clothing load becomes unbalanced, the safety switch will be triggered,
causing the washing machine to automatically refill with water to adjust the imbalance.
Correct
Wrong
Summary of Contents for FCW10BSCWHA
Page 3: ......
