ENGLISH
ENGLISH
GB-31
GB-30
The Cooking
Mode Indicator
comes on, but
heating does not
start.
High temperature of
the hob.
Ambient temperature
may be too high. Air
Intake or Air Vent may
be blocked.
There is something
wrong with the fan.
Check whether the fan
runs smoothly; if not,
replace the fan.
The power board is
damaged.
Replace the power
board.
Heating stops
suddenly during
operation and
the display
flashes “u”.
Pan Type is wrong.
Use the proper pot
(refer to the instruction
manual.)
Pan
detection
circuit is
damaged,
replace the
power board.
Pot diameter is too
small.
Cooker has overheated; Unit is overheated.
Wait for temperature to
return to normal.
Push “ON/OFF”
button to restart unit.
Heating zones
of the same side
( Such as the
first and the
second zone )
would display
“u” .
The power board and
the display board
connected failure;
Check the connection.
The display board of
communicate part is
damaged.
Replace the display
board.
The Main board is
damaged.
Replace the power
board.
Fan motor
sounds
abnormal.
The fan motor is
damaged.
Replace the fan.
The above are the judgment and inspection of
common failures.
Please do not disassemble the unit by yourself to
avoid any dangers and damages to the induction
hob.
9. INSTALLATION
9.1 Selection of installation equipment
Cut out the work surface according to the sizes
shown in the drawing.
For the purpose of installation and use, a
minimum of 5 cm space shall be preserved
around the hole.
Be sure the thickness of the work surface is at
least 30mm. Please select heat-resistant work
surface material to avoid larger deformation
caused by the heat radiation from the hotplate.
As shown below:
L(mm)
W(mm)
H(mm)
D(mm)
A(mm)
B(mm)
X(mm)
590
520
60
56
560+4
+1
490+4
+1
50 mini
Under any circumstances, make sure the
Induction cooker hob is well ventilated and the
air inlet and outlet are not blocked. Ensure the
induction cooker hob is in good work state. As
shown below.
