13
GB
RAC 172
75036036 - RAC172 – rev 02 - ( 04-2019 )
27 mm
B
RAC 172
EAC
M
18 mm
14 mm
M
N
A
MAINTENACE AND CHANGE OF SIZE
(fig.
f4-f5-f6-f7
)
The extended utilization of the riveting tool can cause the slipping
of the clamps on the nail due to the deposited impurities. For
this reason, it is necessary to lubricate the clamps after having
cleaned them with benzine or derivates. However, if clamps are
worn out and as a consequence their working is jeopardized,
replace them.
First remove the head which carries the nozzle (
B
), by means
of a standard spanner of 27 mm. Then, by using two standard
spanners of 18 mm and 14 mm, remove the chuck (
M
) and
extract the clamps (
N
).
The riveting tool is supplied, besides the nozzles set for
FAR
rivets, with a series of accessories for setting high-performance
blind rivets Ø 6,0 / 6,4.
When replacing the nozzle (
A
), use the proper supplied wrench.
WARNING!
Desconnect air feed when performing those
operations.
f4
f5
f6
f7
DISPOSAL OF THE RIVETING TOOL
Follow the prescriptions of the national laws for
disposing of the riveting tool.
After disconnecting the tool from the pneumatic
system, disassemble and split all the components
according to the material: steel, aluminium, plastic
material, etc.
Then proceed to scrap the materials in accordance
with current laws.
