13
GB
FHU 5000
75036031 - FHU5000 – rev 02 - ( 04-2019 )
EAE
EAE
19 mm
H
E
I
FHU 5000
FHU 5000
DEVICE DISPOSAL
For the device disposal, comply with the national laws. After disconnecting the device from energy sources, start the
disassembly of the components according to their material: steel, aluminium, plastic and so on.
Go on with the scrapping in accordance with the nationl standards.
min. 5 Nm
Max 8 Nm
WARNING!!!
DESCONNECT AIR FEED WHEN PERFORMING THOSE OPERATIONS
BEFORE DISCONNECTING THE COMPRESSED AIR HOSE, MAKE SURE THAT IT IS NOT UNDER PRESSURE.
WE RECOMMEND TO USE OIL HLP 32 cSt OR SIMILARS.
TOPPING UP ThE OIL-DYNAMIC CIRCUIT
Verify periodically (15000 cycles), that the oil level does not go below 3/4 of the limit indicated by the proper indicator
(I)
. When topping
up the circuit, remove the plug
(h)
with a 19-mm wrench, then pour hydraulic oil
hLP 32 CST
, until it reaches the edge of the threaded hole.
WARNING!
The mismaintenance of the oil dynamic circuit will cause a stroke decrease that will lead the disfunction of the tool. Therefore, eliminate the
air in the oil dynamic circuit and restore the exact oil level. Proceed as follows: to prevent any oil loss put the tool on a container and hold the upper side
of the booster on the same level of the gun/and lay the feed hoses as the picture shows. Remove the oil screw cap
(h)
, and the service cap
(E)
using for
H a 19 mm wrench and for the other components the appropriate wrenches provided with the tool. Pour oil
hLP 32 cSt
until it flows from the hole, free
from plug
(E)
, completely free from air bubbles. When the operation has been carried out, replace the plug
(E)
and make sure that oil has reached the
border of the threaded hole. Screw the screw cap
(h)
and clean carefully the riveting tool from overflowed oil. It is very important to apply carefully to the
instructions and always wear gloves when you handle the tool. Overflowed oil ,during the topping, must be collected in proper containers and delivered
afterwards, to specialized waste oil getthering company . Do not smash or cut the connecting hoses between gun and booster. Before using the riveting
tool, effect some idling cycles and verify if the level is steady.
WARNING:
Make sure that the oil
filler cap
(E)
is tightened at a torque
corresponding to
min. 5 Nm ÷ Max. 8 Nm.
Summary of Contents for FHU 5000
Page 4: ......
Page 33: ...33 FHU 5000 75036031 FHU5000 rev 02 04 2019...
Page 58: ...RUS 58 FHU 5000 75036031 FHU5000 rev 02 04 2019...
