EN
EN
Manipulation of the winch is very simple and is done in
manoeuvring the telescopic handle after a back and forth
movement whose amplitude is variable according to the
convenience of the operator.
The movements of the market front and rear levers are
double effect, load moving every race of lever in either
direction of movement of the handle.
Store the appliance and the cable in a dry place, protected
from the weather. The cable must be stored on the drum
and completely out of the unit. Before you wrap on his
grinder, it is recommended to inspect it and clean it with
a brush to grease.
1. Lubricate the cable occasionally with light oil.
2. Graissez the gears every 6 months. To do this, remove the
clutch button and separate the left and right housings. Use
any good grade waterproof grease.
SPECIFICATION
EXCLUSION OF LIABILITY
Any divergent application of the application described in the paragraph «Intended use for the intended purpose» is considered to be
inconsistent with the intended application. The manufacturer declines all responsibility for any damages arising from such use.
SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
ATTENTION!
ATTENTION! Do not use the winch for fastening of loads! Shocks can cause loosening of the operated brake by the load.
> Only use the cables with the carabiner is attached firmly by a tight loop of cable.
> Never touch the metal cables without protective gloves.
> When using a Ribbon, respect the limit load.
> The load indicated in the technical data must not be exceeded.
MAINTENANCE
MANEUVER
DECOMMISSIONING AND STORAGE
Type
Maximum load (kg) daN
lower cable layer
top cable layer
Gear ratio of reducer
Cable *
Minimum breaking strength (F min)
Ambient temperature allowed
* Cables according to EN 12385 - 4: class of cable 6 x 19 / 6 x 19 M
182014
360
170
4.2 : 1
Ø 4 mm
17,65 kN
-20°C - +50°C
182014-Manual-B.indd 20
182014-Manual-B.indd 20
06/01/2020 11:39
06/01/2020 11:39
