11
Fantasea Nano Flash Instruction Manual 26110120
can be used to absorb part of the light when
the flash is too powerful, even when set to the
lowest output. In order to install any of the
flash diffusers, first install the Diffuser Holder
on the flash housing by simply clicking it in.
Then slide any of the diffusers through the slot
found at the top of the Diffuser Holder (image
#13). It is recommended to secure both the
Diffuser Holder and the flash diffusers to the
flash by secure strings.
vii.
When the Nano Flash is not in use, it is best to
turn it off in order to prevent exhaustion of the
batteries.
j.
Care & Maintenance
The Nano Flash requires only a minimum amount of care for reliable
performance. The following tips will enable you to get the best results.
i.
Submerge the flash in fresh water for about 20 minutes after every dive in
order to dissolve the salt water crystals from around the controls and
openings of the flash. Manipulate each of the movable controls to assist the
removal of salt particles from these tight areas.
ii.
Allow the flash to dry thoroughly before packing it away for the day or for
the trip home. You may use a soft towel or cloth to dry the flash. Be sure
there is no grease or other debris on the towel.
iii.
Visually check the condition of the O-ring before every dive. If it is dirty,
clean it with fresh water and dry it with a soft cloth as described above. If it
is damaged in any way, such as cut or perforated, replace it immediately.
iv.
It is recommended to slightly lubricate the O-ring periodically. It's important
to note that the amount of lubrication required on the O-ring is only enough
to allow it to slip into place without friction, so it does not twist or become
dislodged. More grease is not necessarily better, and in some cases might
interfere with the watertight seal of the flash.
v.
Do not drop the flash on hard surfaces. It is not a shock absorber, and could
crack, affecting its watertight integrity. It could also cause damage to the
electronic components inside.
vi.
When travelling, remove batteries, leave back the door loose or
unassembled and pack the unit in a protected fashion in a padded case or
bag.
vii.
Never dive with the Nano Flash to a depth greater than 60 meters/200 feet.
viii.
Never store the flash or housing in high temperatures (above 60C/140F
degrees).
Image #13
