4
Fantasea Nano Flash Instruction Manual 26110120
b.
Open the Nano Flash Housing
i.
Release the security lock by gently pulling it out (image #1).
ii.
Rotate the Dial Lock clockwise till it reaches an angle of 45 degrees (image
#2).
iii.
Open the rear cover and take the Nano Flash out of the housing.
c.
Install Batteries Inside the Nano Flash
i.
Make sure that the Pre-Flash Mode Dial is set to the “TEST/OFF” position.
ii.
Open the Nano Flash battery compartment by gently sliding the lid outwards
and then lifting it.
iii.
Install 2 new AAA batteries according to the + and – marks found underneath
the battery compartment lid.
- Do not mix new and old or different types of batteries, as this may lead to an
over-discharge of the weaker battery, resulting with gassing or leaking of fluid
from the battery.
- Please note that the Nano Flash wasn’t designed to be used with
rechargeable batteries.
iv.
Close the battery compartment lid by gently pushing it down and then
inwards. Make sure that once you stop applying pressure on the battery
compartment lid, it remains closed.
v.
Turn on the flash by turning the Pre-Flash Mode Dial to “1”. If batteries were
properly installed, the Ready Light at the back of the flash should turn on after
a few seconds.
vi.
When the Ready Light is on, the flash can be tested by turning the Pre-Flash
Mode Dial back to the “TEST/OFF” position.
vii.
Important Notice: Do not allow any drops of water to enter the battery
compartment when installing or removing batteries.
Image #1
Image #2
