www.fanox.com
Rev. 26
72/188
4.10. Settings table
In SIACxxxxxx2xxxx, this is, the model with inputs:
In adaptation A
, there are three settings tables. The settings table which is active at a specific
moment can be modified in two ways:
Changing the active settings table. In the general group there is a setting which establishes
which table is active.
By means of two inputs. To this end four possibilities are defined.
00
This situation is governed by the active table settings.
01
Table 1
10
Table 2
11
Table 3
In the zero position the active item is defined by the active table settings defined in the general
group. Regarding other options, regardless of that established by the settings, the inputs prevail
over the settings.
If the use of both inputs is not required, then one can be used, but depending on which is used,
operation can be done with table 1 or table 2.
In adaptation B
there are four settings tables and one general table. The settings table which is
active at a specific moment can be modified in two ways:
Changing the active Table settings. In the general group there is a setting which establishes
which table is active (table 1, table 2, table 3 or table 4).
By means of two inputs. To this end four possibilities are defined.
00
This situation is governed by the active table settings.
01
Table 1
10
Table 2
11
Table 3
Table 4 is not possible to be selected through inputs, only through general settings.
In the zero position the active item is defined by the active table settings defined in the general
group. Regarding other options, regardless of that established by the settings, the inputs prevail
over the settings.
If the use of both inputs is not required, then one can be used, but depending on which is used,
operation can be done with table 1 or table 2.
Summary of Contents for SIA-C
