www.fanox.com
Installation_Guide_SIAB000B0010AA_Rev. 03 5 / 32
1.3.1. Keypad & LCD
•
Use KEYPAD to ensure that all the push-buttons work correctly (no difficulties while
pushing them, check out if the relay reacts by pushing each of the buttons)
•
Use KEYPAD to enter in the relay´s menu and make sure that no text is lost while going
from one menu to another.
•
Follow the sequence: Left ◄, Down ▼, Right ►, Up ▲, OK, C and RESET and the
following screen should be displayed:
•
If the contrast of the LCD is ot the correct one, enter to “CONTRAST” menu by holding
“◄” for 3 seconds. Then, change it by using up and dwon buttons to increase or
decrease the contrast.
1.3.2. Test menu
NOTE
: When performing test menu, protection won´t be available and it will be possible to open
circuit breaker. Only authorized personnel can do this job.
Press ◄,▼,► sequentially and hold
OK.
The relay will ask for
the password “5555” to enter to
the test menu (or customer password if default “5555” has been modified).
It will be checked that the LEDs, Magnetic indicator flags and Outputs are activated if OK key is
pressed and it will be deactivated if OK key is pressed again. LEDs, Magnetic indicator and
outputs will be checked to verify the hardware is OK:
Action
Checking
OK
,
OK
Led ON
Led ON activated
▼
,
OK
Led ALARM
Led ALARM activated
▼
,
OK
Magnetic Indicator
Trip Magnetic indicator
▼
,
OK
Trip output
Trip Output activated
C
Skip from test menu
