This manual is designed to make it as easy as possible
to assemble, install, operate, and maintain this ceiling fan
Wiring and connectors must be of type required by
local regulations. The minimum wire would be a 3-
conductor (2-wire with ground).
Tools Needed for Assembly
Materials
(supplied)
screwdriver
WARNING
This fan must be installed by a licensed electrician.
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in
fi
nding your place should you be interrupted.
NOTE:
If you are uncertain of part description, refer to
exploded view illustration.
3
1.
Check to see that you have received the following
parts:
• Fan Motor
Assembly
• Switch Cup Housing/
Adapter Assembly
• Downrod/Hanger Ball
Assembly
• Hanger Bracket
• Ceiling Canopy
• Motor Coupling Cover
Assembly
• Blade Holder Cover Set
• Blade Holder Set
Fan Motor Assembly
Downrod/
Hanger Ball
Assembly
Hanger Bracket
Ceiling Canopy
Motor Coupling Cover Assembly
Switch Cup Housing/
Adapter Assembly
Hardware Bags
Blade Holder
Cover Set
Blade Holder Set
• Hardware bags:
– 1/4-20 Pan head screws with lock
washers (blade holder to fan motor hub)
– 3/16˝-24 Carriage head nuts
– 3/16˝-24 Pan head serrated screws
(blade to blade holder)
– Phillips screwdriver, 10 cm
– 5/32˝ Threaded rods
– 5/32˝ Lockwashers
– Knurled knobs
– Balance Kit
Wall Control
Speed Capacitor
Wall Control
Speed Capacitor
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product.
Substitution of parts or accessories not designated
for use with this product could result in personal injury
or property damage.
IF ANY PART IS DAMAGED OR MISSING,
CALL: 1 3 0 0 4 6 9 3 2 6
